Matching Universal ColorLogic to other existing pool and spa lights

When installing a Universal ColorLogic light into a pool with other existing lights, the desire is to match the color and intensity with the other lights in the pool for consistency.  Here’s how.

Universal ColorLogic is designed to operate in four modes:

Universal ColorLogic (default setting) – Use this mode for new installations and for installations with other Universal ColorLogic/CrystaLogic lights

ColorLogic 4.0 – Use this mode when installing your new light in a pool with ColorLogic 4.0 lights. Universal ColorLogic light will appear as another ColorLogic 4.0 light and will operate the same.

ColorLogic 2.5 – Use this mode when installing your new light in a pool with ColorLogic 2.5 or previous versions.  Universal ColorLogic light will appear as another ColorLogic 2.5 light and will operate the same.

Pentair SAm – Use this mode when installing your new light in a pool with Pentair SAm® or SAL® lights. Universal ColorLogic light will appear as another SAm or SAL light and will operate the same.

How to change modes:

1. Turn on lights and then turn off for between 11-15 seconds
2. Turn on lights and then turn off for between 11-15 seconds
3. Turn on lights and then turn off for between 11-15 seconds
4. The light will blink 1 of 4 colors indicating which mode it is currently in. Refer to the table below to determine which mode you’re in. Note that new lights are shipped in Universal ColorLogic mode (blinking red)

5. To change modes, turn light off and back on. The light will then advance to the next mode. Continue this method until you arrive at the desired mode
6. When the light is in the desired mode, remove power from the lights for at least one minute
7. The light will restart in the new mode the next time it is turned on

For more tricks and tips, visit our web site.

Pentair^® and SAm^® are registered trademarks of Pentair Water Pool and Spa, Inc.^®